of Materials Science and Engineering,
North Carolina State University,
Raleigh NC 27695-7907
email: firstname.lastname@example.org, email@example.com,
** Department of Physics and Astronomy
***Department of Computer Science,
University of North Carolina, Chapel Hill, NC
This is an abstract for a talk to be given at the
Fifth Foresight Conference on Molecular Nanotechnology.
There will be a link from here to the full article when it is available on the web.
One potential application of the carbon nanotubule is in nanoscale mechanical sensors, e.g. nano-vibration gages, strain gages, etc. This paper discusses two aspects important to the development of such devices. Since the discovery of carbon-based nanotubules by Iijima, many theoretical and experimental studies of the electronic and mechanical properties of tubules have been conducted. Currently, experimental work is being conducted at the University of North Carolina-Chapel Hill using the 'Nano-Manipulator', a virtual-reality enhanced atomic force microscope. The microscope is being used to bend large multi-walled tubules. Tubes in the bent state exhibit a series of kinks in the region of the bend. Molecular dynamics simulations are used to provide insight into the dynamics of bending and to explain the existence of multiple kinks in the bent state. In the simulation, a 2000 atom single-walled carbon nanotublue is bent to approximately 60 degrees and then allowed to relax. The simulations show that many kinks form early and coalesce to form a few larger kinks, similar to what is seen in experiment. Stress analysis within the tubule is used to understand these results.
The change in electrical properties in the tubes as a function
of deformation must also be understood in order to develop nano-
sensors. The relative electrical conductivity between pristine
and kinked tubules has been investigated using tight-binding
calculations. Future work will involve bridging the experimental
/ theoretical gap by utilizing increased computational power and
parallel processing to increase the size of computational models
as well as decreasing the size of tubules used in experiment by
the UNC group.
aSupported by the NASA-Ames Computational Nanotechnology Program
bSupported by the National Science Foundation
cSupported by the National Institutes of Health
Donald W. Brenner, Associate Professor, Department of Materials Science and Engineering, Department of Chemistry, Campus Box 7907, North Carolina State University, Raleigh, NC 27695-7907, ph: 919-515-1338, fax: 919-515-7724, email: firstname.lastname@example.org
Foresight materials on the Web are ©1986–2015 Foresight Institute. All rights reserved. Legal Notices.